Digital-alert-systems DASDEC-II QUICK START UP GUIDE Manuel d'utilisateur télécharger pdf (Page 33)

Quick Start Guide for Your DASDEC II Page 33 of 40

9) Next, program the FIPS codes the DASDEC-II will send on that stations interface for weekly

tests. To set that click on the “Setup” tab (circled in red), then click on the “Encoder” radio

button (circled in blue) and finally the “Required Tests” tab (circled in green).

10) From the Encoder pool FIPS codes click on to select which counties this station interface will

issue its weekly tests for (refer to your State EAS plan) and then click “Add Selected FIPS”.

11) The next step in setting up a Station Interface is to enable the audio output. Click on the

“Setup” tab (circled in red), then click on the “Audio” radio button (circled in blue) and finally

the “Encoder Audio” tab (circled in green).

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Digital-alert-systems DASDEC-II QUICK START UP GUIDE Manuel d'utilisateur Page 33